Durston - Draw Bench Assembly Instructions

Twin Speed, Draw Bench Assembly Instructions

Download these instructions
in PDF format

1. Attach the 4 legs

Carefully lay the draw bench on it’s back (chain facing down) and screw on the four legs using the nuts and bolts provided. Ensure you lay the draw bench on something soft so you do not damage the paintwork

2. Fit the 2 cross pieces

Screw the two cross pieces using the nuts and bolts provided

3. Remove Support Pins

Stand the Draw Bench on its legs and unscrew the two support plate pins

4. Fit Draw Plate Support

Insert the draw plate support and then bolt up using the two pins

Durston Rolling Mills - British Made - In use Worldwide - Registered British Design

Site best viewed at 800 x 600

All rights reserved. No part of the publication maybe reproduced, stored in a retrieval system or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior permission of the copyright owner.

Home Manual Rolling Mills Overview of Manual Mills Micro Mill Mini Mill 80 Mini Mill 100 DRM 100 DRM 130 DRM 150 Double Durston 130 D2 130 D4 158 Power Rolling Mills Overview of Power Mills DRM 100 Single Sided DRM 100 Double Sided DRM 130 Single Sided DRM 130 Double Sided Double D2 130 FSM 130 2Hi & 4Hi Mills More Products Overview of More Products Bench Blocks Corrugated Mills Dapping Set Drawbenches Guillotines Ingot Moulds Ring Expander / Reducer Patterns & Profiles Rust Preventive Soldering Flux Tools Cabinet Stand DRM Pedestal Stand Power Stand Custom 200 x 60 Power Mill Double Sided F130 Power Mill D4 158 Power Mill Manual Rolling Mills Power Rolling Mills More Products About Us Download Area User Guide Product Brochure Hi Resolution Images F.A.Q Page News User Guide Trade Accounts Only Contact Us